5.4 AUTOMATED ATTENDANT PARAMETERSInstallation Manual 1635.4.3 Operator’s ParametersIf you enable operator service, you must set the following parameters: Operator’s Extensionand Mailbox Number, Coverage Modes, and Message Repeat Cycle.Operator 1:The default is set at "0" which coincides with the operator of the PBX. When a callertries to leave a message to the Operator 1, the message will automatically go to theGeneral Delivery Mailbox (GDM) by default.Operators 2 and 3:For KX-TDA/TAW series, KX-TD816, KX-TD1232, KX-TD500 and KX-TA1232,Operators 2 and 3 can be assigned to a floating number that is assigned to a ringgroup.Return to Program-Service Setting-Auto. Attn. Setting Menu:Enter the data using the table below as a guide. The table below is for Operator 1 as anexample. Please refer to it for Operators 2 and 3.Table 5-6Description Value Range(Default)Description/FunctionOperatorService1. Disable2. Enable(Enable)Enables or disables the Operator Service feature.NoteAll non-touchtone input calls in AutomatedAttendant Service will be transferred to theGeneral Delivery Mailbox when the OperatorService is disabled.Enter The Number : = 2Program - Service Setting - Auto. Attn. Setting - Operator's Parameters Menu1. Day Mode2. Night Mode3. Lunch Mode4. Break ModeSELECT ITEM AND PRESS KEY1. Operator 12. Operator 23. Operator 3SELECT ITEM AND PRESS KEY
