4.6 DIGITAL INTEGRATION FEATURES AND SETUP PROCEDURES FOR THE PANASONIC KX-TA624, KX-126 Installation Manual4.6.11 Voice Mail Transfer Button Assignment via StationProgrammingThis feature allows an extension user to transfer calls directly to a Voice Mailbox. This isavailable with both Digital and Inband Integrations.PC programming is also available for KX-TD500 users (see 4.6.12 Button Assignment via PCProgramming).1. Enter PITS Programming:For KX-TA624With the phone on-hook, Set the MEMORY switch to "PROGRAM".(Display changes to PITS-PGM Mode.)For KX-T series PBX that uses DPT Integrationa. With the phone on-hook, Press the PROGRAM button.b. Dial [99]. (Display changes to PITS-PGM Mode.)2. Press the desired Flexible (CO or DSS/BLF) button that you want to assign as the VTRbutton.3. Dial [94] (for KX-TA624) or [8] (for KX-T series PBX that uses DPT Integration).Screen output: VTR4. Dial the Voice Mail extension number.Screen output: VTR-_ _ _(_ _ _ = The extension number you entered).5. Press STORE.6. For KX-TA624Set the MEMORY switch to "SET" .For KX-T series PBX that uses DPT IntegrationPress the PROGRAM button or lift the handset.7. Repeat these steps for each telephone.4.6.12 Button Assignment via PC ProgrammingThe KX-TD500 users can assign buttons via PC programming. Follow the procedure below toassign each button.1. Go to "4-2 Extension Line" screen (refer to the screen image in 4.6.6 Live CallScreening Assignment via PC Programming).2. Select the "Card No." and "Port No." which you are going to program.Conditions: This button must be a CO or DSS/BLF key to beprogrammed as a VTR button. When all Voice Mailports are busy and this key is pressed, the user willhear reorder tone.
