8 0 1 4 9l Resource ProgrammingSMDR FormatDescription Used to match the SMDR output to the paper size being used in theprinter. Page length determines the number of lines per page. Skipperforation determines the number of lines to be skipped at the endof every page.SelectionDefault Page length - 66; Skip perforation - 0Programming 1. Enter 801.Conditionsl Page length (lines): 4 through 99l Skip perforation (lines): 0 through 95Display: 801 SMDR FORMAT2. Press NEXT to program page length.Display example: Page Length:663.4.5.Enter the page length.To change the current entry, press CLEAR and enter the new pagelength.Press STORE.Press NEXT to program skip perforation.Display example: Skip Perf: 06. Enter the skip perforation.To change the current entry, press CLEAR and enter the new skipperforation.7. Press STORE.8. Press END.l The page length should be four lines or more longer than the skipperforation length.l A title is positioned on the first three lines on every page.l The programmed format becomes valid only if the Serial Interface (RS-232C) cable is connected. If a printer is already connected, disconnectit and connect again. Otherwise the former format becomes valid.Feature References Section 3, FeaturesStation Message Detail Recording (SMDR)4-130 System Programming.
