4.1.4 User Programming ModeSome programming items are accessible by any display proprietarytelephone user in the system.The programming items are listed below:[OOO] Date and Time Set[OOl] System Speed Dialling Number Set[002] System Speed Dialling Name Set[003] Extension Number Set[O&l] Extension Name Set[005] Flexible CO Button Assignment[006] Operator/Manager Extension Assignment[OOS] Absent Message[OOS] Quick Dial Number SetEntering the user programming modeYou can access these programs by entering the User ProgrammingMode as follows:Before entering the mode, confirm that:l Your telephone is on-hook.l No calls are on hold at your telephonePress PROGRAM (or PAUSE) + * + * and enter the UserPassword (default: 1234)After entering the mode, perform the same programming steps asthe system programming steps in each program address.Note l If your telephone set does not have a PROGRAM button, substitute itwith the PAUSE button.l If nothing is entered in five seconds after the PROGRAM (or PAUSE)button is pressed, it is cancelled.l The User Password is not shown on the display. The password can bechanged by system programming. Refer to Section 4.3 [ 1201 “UserPassword”.l During the programming mode, your extension is treated as a busyextension.l Only one proprietary telephone can be in programming mode at any onetime.4-12 System Programming
