4 3l System Programming 1 1 4VM Command DTMF Set (cbntd.)Selection l LV-MSG / GETMSG / AA-SVC / VM-SVCl DTMF signal number: 16 digits (max.)Default LV-MSG - H; GETMSG - X H; AA-SVC - #8 ; VM-SVC - #6Programming 1. Enter 114.Display: 114 VM DTMF CMD2. Press NEXT to program the LV-MSG command.To program another command, keep pressing NEXT until the desiredcommand is displayed.Display example: LV-MSG:H3. Enter a DTMF signal number.To delete the current entry, press CLEAR.To change the current entry, press CLEAR and enter the new number.4. Press STORE.5. To program another selection, keep pressing NEXT or PREVuntil the desired selection is displayed.6. Repeat steps 3 through 5.7. Press END.Conditions l A command signal number can have a maximum of 16 digits,consisting of 0 through 9, * , ##, FLASH and PAUSE.l The FLASH button is available only for LV-MSG and GETMSGcommands to store “II” which means “Home Position”.l If “II” is stored for “LV-MSG”, a mailbox number programmed inprogram [609] “Voice Mail Access Codes” or an extension number willbe sent to the VM port (Follow On ID function). If certain codes arerequired before and after the ID code, insert “II” between the codes, as“aaaHbbb”. If nothing is stored, it will operate as “II”.l If “ * II” is stored for “GETMSG”, a mailbox number programmed inprogram [609] “Voice Mail Access Codes” or an extension number willbe sent to the port succeeding the “X “.Feature References Section 3, FeaturesVoice Mail IntegrationSystem Programming 4-47
