Conditions• The KX-NCS3910 (Activation Key for Software Upgrade to Enhanced Version) for the KX-NCP500/KX-NCP1000, the KX-NCS4910 (Activation Key for Software Upgrade to Enhanced Version) for theKX-TDE100/KX-TDE200, or the KX-NCS4950 (Activation Key for Software Upgrade to Enhanced Version)for the KX-TDE600 is required to use this feature.• Call disconnection detectionWhen LCOT is used for CO line, the system cannot detect the call disconnection. So the systemdisconnects CO line side after transfer of the call (unscreened transfer).Feature Manual References19.1.2 Virtual PS3.1.15 CLI (Calling Line Identification) DistributionDescriptionDirects an incoming CO line call to a specific destination when the caller’s telephone number matches a numberin the System Speed Dialing Table. Each telephone number in this table can be assigned its own Calling LineIdentification (CLI) destination.CLI distribution allows you to direct calls from specific people to specific destinations, and has manyapplications. For example, you can program the PBX to automatically connect calls from priority clients to theirsales representatives, or automatically connect mobile phone calls from an executive to his or her assistant.In order for CLI distribution to function, the PBX must receive Caller ID information from the telephone company.CLI distribution works in conjunction with both Direct In Line (DIL) and Direct Inward Dialing (DID) distribution;it can be enabled or disabled for each CO line (for DIL) and for each DID number, for each time mode.When a call has Caller ID information and CLI distribution is enabled for the current time mode, CLI distributionwill direct the call to its destination, ignoring preprogrammed DIL or DID destinations.[Programming Example: System Speed Dialing Table]Location(System SpeedDialing No.)000001System SpeedDialing Name*1ABC CompanyXYZ CompanyTelephone No.*2912125551234913135551234CLI Destination*3200300*1 ® 8.1 [6-1] System Speed Dial— Name® [001] System Speed Dialing Number*2 ® 8.1 [6-1] System Speed Dial— CO Line Access Number + Telephone Number® [002] System Speed Dialing Name*3 ® 8.1 [6-1] System Speed Dial— CLI DestinationIn this example:If the caller’s telephone number is "1-212-555-1234":1. The PBX looks for the number in the System Speed Dialing Table. (The CO Line Access number, "9", isdisregarded.) The number is found in location 000.2. If CLI distribution is enabled in the current time mode for the DID number or for the CO line carrying thecall (for DIL distribution), the call is routed to its CLI destination, extension 200.58 Feature Manual Document Version 2013-053.1.15 CLI (Calling Line Identification) Distribution
