Parts and their Functions15Parts and their Functions: Power Supply and Accessory Mounting SectionParts and their Functions1. POWER switchUsed to turn on/off the power.2. Battery mountA battery pack from Anton/Bauer is mounted here.3. DC IN (external power input) socket (XLR, 4P)The unit is connected to an external DC power supply.4. BREAKER switchWhen an excessive amount of current is fed through theunit, due to any abnormal event, the breakerautomatically turns off the power in order to protect thedevice.After the interior of the unit has been checked and/orrepaired, this button must be depressed. If there is nounusual reaction, the unit can be powered-up.5. GPS connectorThis connects the optional GPS unit AJ-GPS910G.6. Shoulder strap fittingsThe shoulder strap is attached here.7. Light shoeA video light or similar accessory can be attached here.8. Lens mount (bayonet 2/3-type)The lens is attached here.9. Lens leverLower this lever to lock the lens to the lens mount.10. Lens mount capTo remove the cap, raise the 9. Lens lever.When the lens is not mounted, replace the cap.11. Light cable clampSecures the light cable.12. Lens cable/microphone cable clampThis clamp secures the lens and microphone cables.13. Tripod mountWhen you want to mount unit on a tripod, the optionaltripod adapter (SHAN-TM700) is attached here.14. LENS jack (12-pin)The lens connection cord is connected here. For adetailed description of your lens, see the relevantmanufacturer’s instruction manual.15. DC OUT (DC power supply output) socketThis output socket is designed for 12 V DC. It provides amaximum current of 1.5 A.Connect an external switch to this socket to controlrecording starts and stops or an LED for use as a tallylamp. For more information, see [Connection of theexternal switch] (page 119).16. Accessory mounting holes (handle)Use these holes to mount accessories. These holesshould not be used for any other purpose.Power Supply and Accessory Mounting Section123461516 5 7 6981014 12 1311
