Honeywell LYNX Touch User Manual

Also see for LYNX Touch L7000 Series: Installation and setup guide Programming guide Quick start guide Programming guide Guide

Contents

Honeywell LYNX Touch User Manual Manual pdf 72 page image

– 72 –REGULATORY AGENCY STATEMENTSREGULATORY AGENCY STATEMENTSREGULATORY AGENCY STATEMENTSREGULATORY AGENCY STATEMENTSFederal Communications Commission (FCC) Part 15The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorizedchanges or modifications could void the user's authority to operate the equipment.CLASS B DIGITAL DEVICE STATEMENTNOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limitsare designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or moreof the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.This Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.Industry Canada (IC)This device complies with Part 15 of FCC Rules and RSS210 of Industry Canada. Operation is subject to the following two conditions: (1) This device maynot cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement est soumis aux conditionssuivantes: (1) Cet appareil ne doit pas causer d' interferences nuisibles. (2) Cet appareil doit accepter toute interference reçue y compris les interferencescausant une reception indésirable.!RF Exposure WarningThe antenna(s) used for this transmitter must be installed to provide a separation distance of at least 7.8 in (20 cm) fromall persons and must notbe co-located or operated in conjunction with any other transmitter except in accordance withFCC multi-transmitter product procedures.Mise en GardeExposition aux Frequences Radio: L'antenne (s) utilisée pour cet émetteur doit être installée à une distance deséparation d'au moins 7,8 pouces (20 cm) de toutes les personnes.