Honeywell LYNX Touch User Manual

Also see for LYNX Touch L7000 Series: Installation and setup guide Programming guide Quick start guide Programming guide Guide

Contents

Honeywell LYNX Touch User Manual Manual pdf 28 page image

– 28 –SECURING THE PREMISESSECURING THE PREMISESSECURING THE PREMISESSECURING THE PREMISESBypassing Protection ZonesBypassing Individual ZonesThe Bypass feature can be used when you want to intentionally arm your system with one or more zonesunprotected. Bypassed zones are unprotected and will not cause an alarm when violated while your system isarmed. All bypasses are removed when an Off sequence is performed. The system will not allowPanic, Fire or CO zones to be bypassed.Bypassing ZonesNot Ready To Arm - Fault7000-100-027-V0Delay MoreMessageZonesFault 2Front Door10:18 AM June 8, 2010System1. With the system in the disarmed state, select the “Zones”icon. The system displays the Zones/Bypass screen.Not Ready To Arm - Fault5200-027-027-V02. FrontDoorSelectFaultFAULTBypass AllFaulted BypassClearBypasses2. Select the zone(s) that you wish to bypass and then select“Bypass” OR if programmed, the “Bypass All Faulted” buttonallows you to bypass all faulted zones (excluding Panic, Fireor CO zones). The system displays a keypad.Not Ready to Arm - FaultBypass Selected ZonesEnter Code:Cancel5200-100-083-V02 315 6408 97Clear3. Enter a valid Code. The system returns to the Bypass screenand the zone(s) that are bypassed will be displayed.4. Select the icon to return to the Security Screen.5. Arm the system normally. See Arming the System section forthe procedure.