Honeywell LYNX Touch User Manual

Also see for LYNX Touch L7000 Series: Installation and setup guide Programming guide Quick start guide Programming guide Guide

Contents

Honeywell LYNX Touch User Manual Manual pdf 18 page image

– 18 –SECURING THE PREMISESSECURING THE PREMISESSECURING THE PREMISESSECURING THE PREMISESArming the SystemArmed Stay7000-100-022-V0MoreMessageZonesDisarm10:18 AM June 8, 2010System4. At the end of the exit delay the system announces“Armed Stay” and displays the “Armed Stay” screen.If an invalid User Code is entered or if a valid user code has not been entered within 10 seconds, the systemwill return to the “home” screen and it will not be armed.Auto Stay Arming FeatureIf this feature is enabled by installer, the LYNX Touch, when armed AWAY from the control’s keypad or a Wireless Keypad,automatically switches to the STAY mode if the Exit Time expires and no exit has been made. Exit must be made throughan Entry/Exit Zone (door). If exit is made through a Garage Door, the system will automatically switch to the STAY modewhen the Exit Time expires.NOTE: If the exit route entry/exit sensor is in a check condition or has been bypassed it will result in a loss of interior protection because thealarm system will arm STAY in this case. Consult with your installer for servicing of the entry exit zones or to turn off this feature if acheck condition on entry exit zones occurs.Arming in Night Stay ModeUse this mode when you are staying home, but require increased security. The mode Arms same as STAY mode,but also arms preselected interior sensors (programmed by your installer), while other interior sensors are leftdisarmed. This mode can be armed when you are staying home but expect someone to use the entrance doorlater. However, persons entering later can enter through an entry/exit door but they must disarm the systemand must not violate any of the programmed interior zones to avoid sounding an alarm. Close all protectedperimeter windows and doors before arming. The green Ready indicator on the control should be lit if thesystem is ready to be armed. When armed in Night STAY mode, the system will sound an alarm if a protectedzone is faulted, but you may otherwise move freely throughout the premises. Late arrivals can enter throughthe designated entrance door without causing an alarm, but they must disarm the system within the entrydelay period or an alarm will occur. If Quick Arm was programmed by the installer, you do not need to enter thesecurity code to arm the system. The security code must always be used to disarm the system, however.When NIGHT-STAY mode is on, the selected interior zones are armed and cause an alarm if anyoneenters those areas (e.g., waking in the middle of the night). To avoid sounding an alarm, you mustdisarm the system before any activity takes place in those interior zones.The Guest Code and Installer Code cannot disarm the system unless it was used to arm thesystem. In addition, if the system is armed by pressing via Quick-Arming, neither the Guest Codenor Installer Code can disarm the system.Ready To Arm7000-100-020-V0Arm AwayDelay MoreMessageSystemArm Stay10:18 AM June 8, 2010Zones1. Select the Arm Stay icon, the system beeps once anddisplays a keypad.