Honeywell LYNX Touch User Manual

Also see for LYNX Touch L7000 Series: Installation and setup guide Programming guide Quick start guide Programming guide Guide

Contents

Honeywell LYNX Touch User Manual Manual pdf 38 page image

– 38 –USER FUNCTIONSUSER FUNCTIONSUSER FUNCTIONSUSER FUNCTIONSMessage Recording and PlaybackThe LYNX Touch Message Center allows you to record, play and delete messages. The maximum messageduration is 184 seconds.NOTES: (1) If the system loses electrical power, all messages will be erased.(2) Message Play/Record will not be available if a report must be sent.Entering Message ModeReady To Arm7000-100-020-V0Arm AwayDelay MoreMessageSystemArm Stay10:18 AM June 8, 2010Zones1. With the system in the disarmed state, select the “Message”icon from the Security Screen. The system displays theMessage screen.Recording a MessageReady To ArmSave5200-100-045-V0No items to display!Add New Delete AllPlay1. Select “Add New”. The system displays the Record Messagescreen.Note: The System will display the total message recording timeavailable.Ready To Arm5200-100-046-V0Time Remaining : 184 SecondsMessage 1 StoppedRecord DeletePlay2. Select “Record”, the system sounds a single tone. Speak intothe microphone and record your message.3. When you are finished recording your message, select. “Stop”4. To listen to the message, select “Play”.5. If you wish to delete the message, select “Delete”.6. Record additional messages as required.5200-100-047-V0Message 1 2:48 PM September 1, 2010Message 2 5:09 PM September 5, 2010Add New Delete AllPlayReady To Arm 6. When you have finished recording, select “”. The systemdisplays the recorded messages.7. To record additional messages (if recording time is available)repeat steps 1 through 3.NOTE: If you are trying to record a new message and the message center is already full, “Add New” will not be displayed. If themessage center is full all old messages must be deleted before new messages can be recorded. See the DeletingMessages section.