Honeywell LYNX Touch User Manual

Also see for LYNX Touch L7000 Series: Installation and setup guide Programming guide Quick start guide Programming guide Guide

Contents

Honeywell LYNX Touch User Manual Manual pdf 24 page image

– 24 –SECURING THE PREMISESSECURING THE PREMISESSECURING THE PREMISESSECURING THE PREMISESEntry/Exit DelaysEntry/Exit DelaysEntry/Exit DelaysEntry/Exit DelaysExit DelayExit delay begins immediately after arming the system, and gives you time to leave through the designated exitdoor without setting off an alarm. The system display will count down the time remaining in the exit delay, ifprogrammed by your installer. If the system has been Armed Away, a slow beeping will sound throughout theexit delay period, if programmed by your installer. The exit door must be closed before the end of the exit delay.During the last 10 seconds of the exit delay fast beeps will sound as a warning that the delay time is nearing itsend. The exit beeps cannot be silenced.Restarting Exit Delay While System ArmedAsk your installer if this feature is active for your system. If active, you can restart the exit delay one time afterarming in Stay or Away mode during the exit delay by selecting the “Restart” key. This will allowing extra timefor someone to enter or exit or re-enter the property before the system is armed.Armed Stay - Exit NowExit now28 seconds7000-100-021-V0MoreMessageZonesDisarm Restart10:18 AM June 8, 2010SystemExit AlarmsTo minimize false alarms sent to the alarm monitoring company, your system may have been programmed forthis feature. Ask your installer if Exit Alarm is active for your system.Whenever you arm the system, the exit delay begins. If an entry/exit door or interior zone is faulted when theexit delay ends (e.g., exit door left open), the system sounds an alarm and starts the entry delay timer. If youdisarm the system before the entry delay ends, the alarm sound stops and the message “Alarm Cancelled isdisplayed, in the system bar. Additionally, Alarm and the faulted zone are displayed with their associated iconsin the system/zone status area. No message is sent to the alarm monitoring company. To clear the exit alarmcondition, the open zone must be secured. To clear the display, select the “Disarm” icon OR depress the “Off”key and then enter your security code.If you do not disarm the system before the entry delay ends, and an entry/exit door or interior zone is still open,the alarm sound continues and an "exit alarm" message is sent to the alarm monitoring company. The message“Alarm Exit Error" is displayed, in the system bar. Additionally, Alarm and the faulted zone are displayed withtheir associated icons in the system/zone status area. The alarm will continue to sound until the system isdisarmed or timeout ocurs. To stop the alarm, the system must be disarmed by selecting the “Disarm”icon OR depressing the “Off” key and then entering your security code. The message “Alarm Cancelled" isdisplayed, in the system bar, indicating that the alarm has been cancelled (if this feature is enabled by theinstaller). “Alarm” and the faulted zone continue to be displayed with their associated icons in the system/zonestatus area. To clear the display, select the “Disarm” icon OR depress the “Off” key and then enter your securitycode a second time. An exit alarm also results if an entry/exit door or interior zone is faulted within twominutes after the end of the exit delay.