GE D25 User Manual

Contents

GE D25 User Manual Manual pdf 27 page image

GE Grid Solutions D25User's ManualGE Information 994-0081-3.00-21 27Configuration of a GDPConfiguring aGDP’sSoftwareA D25 fitted with a GDP must be equipped with the DNP 3.0 DPAapplication software and will use the COM1 (D25 MAINT port) tocommunicate with the GDP. Using SGConfig, some or all of the D25’sdatabase points are mapped into this communication software.Inside the GDP, these points are then mapped into the GDP graphic objects.For detailed information about configuring the DNP 3.0 DPA, refer to theB021-0CG Configuration Guide.For detailed information about setting up and configuring the GDP, refer tothe “IGPM 16200 Operation and Configuration Manual” (document number16200-MOC-09-08-E).To access the GDP manual:1. Go to GE Grid Solutions Technical Support at:http://www.gegridsolutions.com/TDSASSupport2. Log in to the Technical Support Library.3. Navigate to Substation Automation Products > D25 > GDP –Monochrome > FW 603 Upgrade > Substation Bay Config Tool Ver5.01.4. Download and extract the file; the manual is located in the Manualfolder.Please contact GE Grid Solutions to learn more about the configuration toolsand settings available for the GDP.GDP HardwareConnectionsWhen installed, the PSA module (part # 521-0131) is mounted over the right-hand side of the D25’s DAC board, where it plugs onto the three sets ofdigital input wetting jumpers (see Low-Voltage Digital Input Card Wetting onp. 120 for more detail on these jumpers). The PSA taps into the main D25power supply’s field output through these jumpers.A flat ribbon cable (Part # 976-0126) connects from the PSA card to theIndicator Switch card (Part # 540-0412) mounted on the inside the front doorof the D25 enclosure. This cable is the data connection to the GDP.Another cable (Part # 976-0127) links the PSA card to the GDP. This cable isboth the DC power connections from the PSA to the GDP, as well as the RS-485 data interface.