D25User's Manual GE Grid Solutions132 994-0081-3.00-21 GE InformationDigital Output CardKE Card Mount the KE Card component-side down in the fifth slot (from the top of theD25):!Use PullersAlways use the pullers shipped with the D25 to remove and replace KE Card.The high voltage area of the D25 High Current KE Digital Output Module is in closeproximity to the D25 chassis. Ensure that relay contacts are de-energized beforeremoving the D25 HCKE Digital Output Module.Removing theKE CardUsing one PCB puller, slide the KE Card toward the front of the D25.Use firm but gentle pressure when pulling the card out.Replacing theKE CardPosition the KE Card component side down in the fifth slot from the top ofthe D25, and carefully push the card into the D25 housing.Use firm but gentle pressure to push the card into place.KE CardThe KE Card must be installed component side down.Attempts to install the KE Card in any other orientation will cause damage tothe components.DO Board(Upside Down)
