equipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.• Consult the dealer or an experienced radio/TV technician for help.Use of a shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC Rules.Do not make any changes or modifications to the equipment unless otherwise specified in the manual. Ifsuch changes or modifications should be made, you could be required to stop operation of the equipment.FCC ID:AZDK30357Changes or modifications not expressly approved by the party responsible for compliance could void theuser's authority to operate equipment.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.The equipment complies with FCC radiation exposure limits for at uncontrolled equipment. Thisequipment should be installed and operated with minimum distance at least 20cm between the radiatorand persons body (excluding extremities: hands, wrists, feet and ankles) and must not be colocated oroperated with any other antenna or transmitter.Canon U.S.A., Inc.One Canon ParkMelville, New York 117471-800-652-2666Pre-Installation RequirementsOrder InformationWhen ordering service from the telephone company for this equipment, the following may be required.Universal Service Order Code (USOC): RJ11CThe Facility Interface Code (FIC): 02LS2Service Order Code (SOC): 9.0FConnection of the EquipmentThis equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA.On the bottom of this equipment is a label that contains, among other information, a product identifier inthe format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.The REN is used to determine the number of devices that may be connected to a telephone line.Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call.In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number ofdevices that may be connected to a line, as determined by the total RENs, contact the local telephonecompany. The REN for this product is part of the product identifier that has the formatUS:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g., 03 is aREN of 0.3).49
