98 EditingE7. Press the STOP 3 button on the wireless controllerto stop dubbing.Audio device: Stop playback.Set the zero set memory at the end of the scene you wish to dub audio. Thecamcorder will automatically stop audio dubbing at that point.Playing Back the Added SoundYou can select to play back Stereo 1 (original sound), Stereo 2 (added sound), or adjustthe balance of both sounds.1. Open the menu and select [AUDIO SET UP]. Select [12bit AUDIO OUT],select a setting and close the menu.• STEREO1: Plays back the original sound.• STEREO2: Plays back the added sound.• MIX/FIXED: Plays back stereo 1 and stereo 2 in the same level.• MIX/VARI.: Plays back stereo 1 and stereo 2. The mix balance can be adjusted.2. If you have selected [MIX/VARI.], adjust the mix level: Open the menuand select [AUDIO SET UP]. Select [MIX BALANCE], adjust the balancewith the selector dial and close the menu.Turn the selector dial down to increase the volume of Stereo 1 and up to increase thevolume of Stereo 2.❍ The camcorder resets to [STEREO1] when you turn the camcorder off. However,the mix balance is memorized by the camcorder.❍ You can also press the 12bit AUDIO OUT button on the wireless controller toselect the audio output. However, the mix balance can only be adjusted in themenu.CARD CAMERACARD CAMERAPLAY (VCR)CAMERAREWPAUSEAV INSERT AV DV REMOTE SETSLOW 2PLAYSTOPFFZERO SETMEMORY12bitAUDIO OUTAUDIO DUB.MENU buttonSelector dial12bit AUDIOOUT button12bit AUDIO•••STEREO1AUDIO SET UP( 42)4_D74PAL_E(87-99) 03.1.27 7:05 PM Page 98
