143AdditionalInformationEList of MessagesMessage ExplanationYou have not set the time zone, date and time. This messageappears each time you turn the power on until you set thetime zone, date and time.Battery pack is exhausted. Replace or charge the batterypack.Cassette is protected. Replace the cassette or change theposition of the protect switch.Camcorder stopped operating to protect the tape. Unloadand reload the cassette.DV cable is not connected, or the connected digital device isturned off.Condensation has been detected in the camcorder.Tape reached the end. Rewind the tape or replace thecassette.You attempted to perform audio dubbing or AV insert on atape recorded in a mode other than the SP mode.You attempted to perform audio dubbing on a taperecorded in 16-bit or 12-bit 4-channel sound.You attempted to perform audio dubbing or AV insert on atape with a blank section.Video heads are dirty. Clean the video heads.You attempted to play back a copyright protected tape.You attempted to dub a copyright protected tape. May alsoappear when an anomalous signal is received during analogline-in recording, or during analog-digital conversion of acopyright protected tape.SET THE TIME ZONE,DATE AND TIMECHANGE THEBATTERY PACKTHE TAPE IS SET FORERASURE PREVENTIONREMOVE THECASSETTECHECK THE DV INPUTCONDENSATION HASBEEN DETECTEDTAPE ENDCHECK THE CASSETTE[REC MODE]CHECK THE CASSETTE[AUDIO MODE]CHECK THE CASSETTE[BLANK]HEADS DIRTY, USECLEANING CASSETTECOPYRIGHT PROTECTEDPLAYBACK IS RESTRICTEDCOPYRIGHTPROTECTED DUBBINGRESTRICTED23142120881472051969414791916_D74PAL_E(139-159) 03.1.27 7:50 PM Page 143
