92 EditingEConverting Analog Signals into DigitalSignals (Analog-Digital Converter)By connecting the camcorder to a VCR or 8mm video camcorder, you can convertanalog video/audio signals to digital signals and output the digital signals via the DVterminal. The DV terminal serves as output terminal only.❍ Headphones cannot be used during analog-digital conversion.❍ Unload the tape from the camcorder.❍ Turn off all devices before starting the connections.❍ Depending on the signal sent from the connected device, the conversion fromanalog to digital signals might not work properly (e.g., signals that includecopyright protective signals or anomalous signals such as ghost signals).❍ When connecting to a TV/video with SCART terminal, use a SCART adapterwith input capability (commercially available). The supplied SCART AdapterPC-A10 is for output only.We recommend powering the camcorder from a household power source.Connecting the DevicesThis illustration shows how to connect using a S-video cable. You can also connect theyellow plug of the stereo video cable to the VIDEO terminal. Refer also to theinstruction manual of the connected device.OUTPUTAUDIOVIDEOS(S1)-VIDEORLDVSignal flowS-150 S-video Cable(optional)STV-250N Stereo VideoCable (supplied)4 pin - 4 pin: CV-150F DV Cable (optional)4 pin - 6 pin: CV-250F DV Cable (optional)Signal flowSignal flow4_D74PAL_E(87-99) 03.2.11 10:13 AM Page 92
