IJ Scan Utility Error MessagesIf an error message for IJ Scan Utility appears, check the error code and follow the corresponding solution.Error Code Error Message Solution152 There is not enough memory. Exit other applications to increaseavailable memory.• The memory required tostart IJ Scan Utility cannotbe obtained; exit other appli-cations.153 The image you attempted to scan is in a size that cannot beopened in the specified application. Change the settings so thatthe image size is reduced.• Reduce the resolution oroutput size and scan again.201 A required file is missing or corrupted, or settings are incorrect.Try the installation again.• Delete MP Drivers, then re-install MP Drivers from theSetup CD-ROM or our web-site.For how to delete MP Driv-ers, see Deleting the Unnec-essary MP Drivers.202 An internal error has occurred. Take the following measures.- Check the scanner status.- Restart the scanner.- Restart the computer, then try again.- Reinstall the scanner driver.• An internal error has occur-red. Take the followingmeasures.◦ Check the scanner sta-tus.◦ Restart the scanner.◦ Restart the computer,then try again.◦ Reinstall MP Drivers.230 A scanner driver supporting this software is not installed. Install itand try again.• Reinstall MP Drivers fromthe Setup CD-ROM or ourwebsite.231 Cannot complete the scan. The disk space is insufficient. • Delete unnecessary files onthe hard disk and scanagain.232 Cannot save the file. The disk is write-protected.Cancel the protection or use another disk.• Cancel the write protectionon the disk.234 This scan function is not supported by the selected model. Se-lect a different scan function.• Select a different scan func-tion.242 Cannot write file. • Check the access permis-sion on the folder in Folderto Save Temporary Files inthe Settings (General Set-tings) dialog box or Save in1155
