Machine Cannot Be Used After Replacing Wireless Router orChanging Its SettingsWhen you replace a wireless router, redo the network setup for the printer.• For Windows:Use the Setup CD-ROM or follow the instructions on the Canon website.• For Mac OS:Follow the instructions on the Canon website.If this does not solve the problem, see below.Cannot Communicate with Printer After Enabling MAC/IP Address Filtering or Encryption Key onWireless RouterWith Encryption On, Cannot Communicate with Printer After Changing Encryption Type at WirelessRouterCannot Communicate with Printer After Enabling MAC/IP AddressFiltering or Encryption Key on Wireless RouterCheck1 Check wireless router setting.To check the wireless router setting, see the instruction manual provided with the wireless router or contact itsmanufacturer. Make sure the computer and the wireless router can communicate with each other under thissetting.Check2 If filtering MAC addresses or IP addresses at wireless router, check that MACaddresses or IP addresses for computer, network device, and printer are registered.Check3 If using WPA/WPA2 or WEP key, make sure encryption key for computer,network device, and printer matches key set for wireless router.Not only the WEP key itself, but also the key length, key format, the key ID to use, and the authenticationmethod must be the same for the printer, the wireless router, and the computer.For details, see Setting an Encryption Key.1085
