9 Press ▲ or ▼ to select the pattern number you have decided, and then press the OK button.Test pattern B is printed for adjustment.Note• If you printed test pattern A on a sheet, follow the instructions on the Display Screen and use anothersheet of the same type of paper.Additionally, after test pattern B is printed, follow the instructions on the Display Screen and remove thesheet.10 Examine test pattern B for adjustment. Determine the pattern in which banding is least noticeable.11 Press ▲ or ▼ to select the pattern number you have decided, and then press the OK button.The adjustment value is now registered, and adjustment is complete.Fine-Tuning the Paper Feed AmountFine-Tuning the Paper Feed AmountIf the contrast is uneven or banding in different colors appears at 50 mm (2.0 in) intervals in printed documents, tryexecuting Adj. Fine Feed during printing to fine-tune the feed amount.Note• The Adj. Fine Feed menu is only displayed during printing.Additionally, it is displayed when you have selected Automatic or Print Quality in Adj. Priority in Feed Priority.(See "Menu Settings.") ➔ P.449• Always execute Adj. Quality before Adj. Fine Feed.Once you execute Adj. Quality, the Adj. Fine Feed value will revert to 0.(See "Automatic Banding Adjustment.") ➔ P.565(See "Manual Banding Adjustment.") ➔ P.566Perform adjustment as follows.1 On the Tab Selection screen of the Control Panel, press ◀ or ▶ toselect the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.2 Press the OK button.The Set./Adj. Menu is displayed.3 Press ▲ or ▼ to select Adj. Fine Feed, and then press the OK button.4 Press ▲ or ▼ to select a setting value in the range -5 to 5, and then press the OK button.At this time, if banding in dark colors appears, select a setting value in the range 1 to 5, and if banding inlight colors appears, select a setting value in the range -1 to -5.Adjusting Line LengthAdjusting Line LengthTo ensure that lines in CAD drawings are printed at exactly the right length, use Adjust Length to adjust theamount that paper is advanced.There are two options in Adjust Length : AdjustmentPrint and Change Settings.• AdjustmentPrintAfter a test pattern is printed, you will measure the discrepancy based on the results of printing.• Change SettingsNo test pattern is printed. Instead, you will measure a document already printed to determine the discrepancy.Fine-Tuning the Paper Feed Amount iPF850User's GuideAdjustments for Better Print Quality Adjusting the feed amount568
