Problems Regarding PaperProblems Regarding PaperClearing Jammed Roll Paper .......................................................................................................................... 619Clearing a Jammed Sheet .............................................................................................................................. 622If There is a Paper Jam while Using the Stacker ............................................................................................. 624Troubleshooting When Paper Jams are not Found .......................................................................................... 625Roll paper cannot be inserted into the Paper Feed Slot .................................................................................. 628Cannot load sheets ........................................................................................................................................ 628Paper is not cut neatly .................................................................................................................................... 628Paper is not cut .............................................................................................................................................. 628The Stacker continues to rotate ...................................................................................................................... 629The size of clear film cannot be detected ........................................................................................................ 629Clearing Jammed Roll PaperClearing Jammed Roll PaperIf roll paper jams, follow the steps below to remove jams.Note• If you do not find any scraps or jams, see "Troubleshooting When Paper Jams are not Found." ➔ P.625• If the paper becomes jammed while ejecting to the stacker, see "If There is a Paper Jam while Using the Stack-er." ➔ P.6241 Turn the printer off. (See "Turning the Printer On and Off.") ➔P.172 Open the Top Cover.Note• If the leading edge of the roll jams in the carriage such as when the paper curls strongly, you may be ableto avoid paper jamming by setting the roll cutting method to Manual and setting the detection of paperleading edge to Do not perform.(See "Specifying the Cutting Method for Rolls.") ➔ P.3603 If the Carriage is out, move the Carriage out of the way,away from the paper.iPF850 Clearing Jammed Roll PaperUser's GuideTroubleshooting Problems Regarding Paper619
