HP-GL/2 problemsHP-GL/2 problemsWith HP-GL/2, printing is misaligned .............................................................................................................. 644Lines or images are missing in printed HP-GL/2 jobs. ..................................................................................... 644Lines are printed too thick or thin in HP-GL/2 print jobs .................................................................................. 644HP-GL/2 jobs are printed in monochrome (or color) ........................................................................................ 644Printed colors of lines are inaccurate during HP-GL/2 printing ........................................................................ 645HP-GL/2 jobs are printed 6 mm larger than specified ..................................................................................... 645HP-GL/2 jobs are printed at maximum size, even if a standard size is specified .............................................. 645HP-GL/2 printing takes a long time ................................................................................................................. 645The printer stops when printing a HP-GL/2 job (the carriage stops moving) .................................................... 645With HP-GL/2, printing is misalignedWith HP-GL/2, printing is misalignedCause Corrective ActionThe plotter origin is incorrect. Check the printing commands.Set Detect img size to Command priority or Detected size in the Control Panelmenu.(See "Menu Settings.") âž” P.449The Margin setting in the Control Panelmenu is incorrect.Adjust the Margin setting values in the Control Panel menu.(See "Menu Settings.") âž” P.449Lines or images are missing in printed HP-GL/2 jobs.Lines or images are missing in printed HP-GL/2 jobs.Cause Corrective ActionThe memory is full. Check the size of the data in the print job.An HP-GL/2 command not supported by this printer wasreceived.Check the print job and settings.The printer has received print data that includes HP RTLcommands when Auto Rotate is On in the Control Pan-el menu.In the Control Panel, set Auto Rotate to Off and print again.(See "Menu Settings.") âž” P.449The plotter origin is incorrect. Set Detect img size to Command priority or Detected size in the Con-trol Panel menu.(See "Menu Settings.") âž” P.449Oversize in the Control Panel menu is set to Off. Set Oversize to On in the Control Panel menu.(See "Menu Settings.") âž” P.449Lines are printed too thick or thin in HP-GL/2 print jobsLines are printed too thick or thin in HP-GL/2 print jobsCause Corrective ActionThe Width setting in the Control Panel menuis incorrect.Change the Width setting configured in Pen no. of the Palette A or Palette B selec-ted in the Control Panel menu.(See "Menu Settings.") âž” P.449ThickenFineLines in the Control Panelmenu is set to Off.If fine lines are printed faintly, setting ThickenFineLines to On will print the linesmore distinctly.(See "Menu Settings.") âž” P.449The Ln wdth correct setting in the ControlPanel menu is incorrect.Change the Ln wdth correct setting in the Control Panel menu.(See "Menu Settings.") âž” P.449HP-GL/2 jobs are printed in monochrome (or color)HP-GL/2 jobs are printed in monochrome (or color)Cause Corrective ActionThe Color Mode setting in theControl Panel menu is incor-rect.Check the Color Mode setting in the Control Panel menu.(See "Menu Settings.") âž” P.449However, for optimal Printhead performance, the printer consumes trace amounts of color ink evenwhen Monochrome is selected as Color Mode.With HP-GL/2, printing is misaligned iPF850User's GuideTroubleshooting HP-GL/2 problems644
