Initial SettingsInitial SettingsConfiguring the IP Address on the Printer ....................................................................................................... 486Configuring the IP Address Using imagePROGRAF Device Setup Utility .................................................... 497Configuring the IP Address Using the Printer Control Panel ....................................................................... 486Configuring the IP Address Using ARP and PING Commands ................................................................... 487Configuring TCP/IPv6 Network Settings ......................................................................................................... 488Configuring the Printer Driver Destination (Windows) ...................................................................................... 489Configuring the Printer Driver Destination (Mac OS) ........................................................................................ 489Configuring the Printer's TCP/IP Network Settings With RemoteUI ................................................................. 490Configuring the IP Address on the PrinterConfiguring the IP Address on the PrinterYou must configure the printer's IP address before using the printer in a TCP/IP network.The printer's IP address is configured automatically when you install the printer driver following the instructions inthe Setup Guide.Configure the IP address by using imagePROGRAF Device Setup Utility, the printer Control Panel, or ARP orPING commands, if the IP address is changed, or if you change the printer connection mode to a network connec-tion. For details on configuring the IP address, refer to the following topics.• Configuring the IP Address Using imagePROGRAF Device Setup Utility ➔P.497 (Windows)• Configuring the IP Address Using the Printer Control Panel ➔P.486• Configuring the IP Address Using ARP and PING Commands ➔P.487Important• If you use a DHCP server for automatic assignment of the printer's IP address, printing may no longer be possi-ble after the printer is turned off and on. This is because an IP address different from before has been assigned.Thus, when using DHCP server functions, consult your network administrator and configure the settings in one ofthe following ways.• Configure the setting for dynamic DNS updatingIn the printer menu, either set DNS Dync update to On, or activate the setting Enable DNS Dynamic Update inRemoteUI.(See "Menu Settings.") ➔ P.449(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.") ➔ P.490• Configure the setting for assignment of the same IP address each time the printer starts upNote• We recommend configuring the printer's IP address even if you will use the printer in networks other than TCP/IPnetworks. Configuring the printer's IP address enables you to use RemoteUI to configure the network settings andmanage the printer with a web browser.For details on RemoteUI, see "Using RemoteUI." ➔ P.484Configuring the IP Address Using the Printer Control PanelConfiguring the IP Address Using the Printer Control PanelThis topic describes how to configure the printer's IP address on the Control Panel.1 On the Tab Selection screen of the Control Panel, press ◀ or ▶ toselect the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.Configuring the IP Address on the Printer iPF850User's GuideNetwork Setting Initial Settings486
