Roll x is empty. (x is 1 (Upper) or 2 (Lower))Roll x is empty. (x is 1 (Upper) or 2 (Lower))Cause Corrective ActionThe tailing edge of thepaper was detectedbecause cut sheetswere loaded in the rollpaper Paper Feed Slot.Follow these steps to install the roll paper.1. Press the OK button and remove the paper.2. Load the new roll.(See "Attaching the Roll Holder to Rolls.") âž” P.342(See "Loading Rolls in the Printer.") âž” P.3453. If no barcode was printed on the roll, specify the type of paper.(See "Changing the Type of Paper.") âž” P.3504. If no barcode was printed on the roll, specify the paper length.(See "Specifying the Paper Length.") âž” P.3525. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, pressthe OK button.Printing will resume, starting from the page on which the error occurred."Lift the release lever and replace the roll."Cause Corrective ActionThe roll is empty. Follow these steps to replace the used roll with a new roll of the sametype and size.1. Lift the Release Lever and remove the roll.(See "Removing the Roll from the Printer.") âž” P.352(See "Removing the Roll Holder from Rolls.") âž” P.3562. Load the new roll.(See "Attaching the Roll Holder to Rolls.") âž” P.342(See "Loading Rolls in the Printer.") âž” P.3453. If no barcode was printed on the roll, specify the type of paper.(See "Changing the Type of Paper.") âž” P.3504. If no barcode was printed on the roll, specify the paper length.(See "Specifying the Paper Length.") âž” P.3525. If "Not finished printing. Finish printing remaining jobs?" isshown on the Display Screen, press the OK button.Printing will resume, starting from the page on which the error oc-curred.There is remaining roll paper, but because it could not beadvanced, it could not be detected.The unused portion of the roll is heavy, and this is placing a burden onthe printer. It may be helpful to change the printing mode, which willchange the paper feed timing.Choose a higher level of Print Quality in the Advanced Settings ofthe printer driver.(See "Giving Priority to Particular Graphic Elements and Colors forPrinting.") âž” P.66No Roll Unit.No Roll Unit.Cause Corrective ActionThe printer has received a print job that specifies Roll 2 (Lower), but the RollUnit is not installed.Press the Stop button and stop printing.1. Turn the printer off and install the Roll Unit.Connect the Roll Unit Cable firmly and completely.2. Turn the printer on and resend the print job.Roll x is empty. (x is 1 (Upper) or 2 (Lower)) iPF850User's GuideError Message Messages regarding paper658
