Cause Corrective ActionYou are using paper that isnot compatible with auto-matic cutting.Specify Manual as the cutting method and cut the roll manually.(See "Specifying the Cutting Method for Rolls.") âž” P.360For information about paper that is compatible with automatic cutting, see the Paper ReferenceGuide.(See "Displaying the Paper Reference Guide.") âž” P.335The Cutter Unit stops in themiddle of cutting.If the Carriage is out, move the Carriage out of the way, away from the paper.If the Cutter is out, move the Cutter to the right side (away from the paper) and remove the jammedpaper.(See "Clearing Jammed Roll Paper.") âž” P.619If the paper cannot be cut using the Cutter Unit, specify Manual as the roll cutting method and cut theroll manually.(See "Specifying the Cutting Method for Rolls.") âž” P.360In other cases, the CutterUnit may be damaged.Contact your Canon dealer for assistance.End of paper feed.End of paper feed.Cause Corrective ActionAlthough an attempt was made to advance the paper manually, it reached the limitposition that can be advanced.Canceling manual advancing.(See "Feeding Roll Paper Manually.") âž” P.357Rel lever is in wrong position.Rel lever is in wrong position.Cause Corrective ActionThe Release Lever is up. Lower the Release Lever.If the error occurs again, turn off the printer and wait a while before restoring power.Borderless printng not possible.Borderless printng not possible.Cause Corrective ActionThe print job received specifies atype or width of paper that is notcompatible with borderless print-ing.Follow these steps to change the settings of the print job to enable borderless printing.1. Press â–˛ or â–Ľ to select Stop Printing, and then press the OK button.2. Make sure the correct printer driver for the printer is selected and try printing again.For information on types of paper compatible with borderless printing, refer to the PaperReference Guide.(See "Displaying the Paper Reference Guide.") âž” P.335Press â–˛ or â–Ľ to select Print With Border, and then press the OK button to continue printing.The document will be printed with a border.The loaded paper is a size notcompatible with borderless print-ing.Press â–˛ or â–Ľ to select Stop Printing, and then press the OK button.Replace the paper with paper compatible for borderless printing as follows.1. Press â–˛ or â–Ľ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") âž” P.352(See "Removing the Roll Holder from Rolls.") âž” P.3562. Replace the paper with paper compatible for borderless printing.(See "Attaching the Roll Holder to Rolls.") âž” P.342(See "Loading Rolls in the Printer.") âž” P.345The printer now starts printing the print job.For information on types of paper compatible with borderless printing, refer to the PaperReference Guide.(See "Displaying the Paper Reference Guide.") âž” P.335Press â–˛ or â–Ľ to select Print With Border, and then press the OK button to continue printing.The document will be printed with a border.Because paper expands or con-tracts depending on the environ-ment of use, it may become nar-rower or wider than the supportedwidth for borderless printing.Use each type of paper only where the recommended environmental conditions are met. Fordetails on environmental conditions for various paper, see the Paper Reference Guide.(See "Displaying the Paper Reference Guide.") âž” P.335iPF850 End of paper feed.User's GuideError Message Messages regarding paper661
