2 Press the OK button.The Paper Menu is displayed.3 Press ▲ or ▼ to select Paper Details, and then press the OK button.4 Press ▲ or ▼ to select the type of paper, and then press the OK button.5 Press ▲ or ▼ to select Trim Edge First, and then press the OK button.6 Press ▲ or ▼ to select the desired setting option, and then press the OK button.This setting takes effect the next time you load a roll.Reducing Dust from Cutting RollsReducing Dust from Cutting RollsFor media such as Backlit Film that are more likely to generate debris when cut, select CutDustReduct. > On inthe Paper Menu of the Control Panel. This option reduces debris from cutting by printing black lines at the leadingand trailing edges of documents. It may help prevent Printhead damage. You can specify for CutDustReduct. to beactivated for particular types of paper.Important• Do not set CutDustReduct. to On for paper that wrinkles easily, such as Plain Paper or lightweight paper. Thismay impair cutting and cause paper jams.• Borderless printing is not available when CutDustReduct. is set to On. To use borderless printing, select Cut-DustReduct. > Off.Set CutDustReduct. to On as follows.1 On the Tab Selection screen of the Control Panel, press ◀ or ▶ toselect the Paper tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.2 Press the OK button.The Paper Menu is displayed.3 Press ▲ or ▼ to select Paper Details, and then press the OK button.4 Press ▲ or ▼ to select the type of paper loaded in the printer, and then press the OK button.5 Press ▲ or ▼ to select CutDustReduct., and then press the OK button.6 Press ▲ or ▼ to select On, and then press the OK button.iPF850 Reducing Dust from Cutting RollsUser's GuideHandling and Use of Paper Handling rolls367
