Menu SettingsMenu SettingsMenu items are as follows.The printer menu is classified into regular menu items available when no print job is in progress and menu duringprinting items only available while printing is in progress. see "Printer Menu Operations." ➔P.439Regular menu Menu during printingPaper Menu Not displayedInk Menu The same Ink Menu as normal is displayed.Job Menu The same Job Menu as normal is displayed.Set./Adj. Menu A limited Set./Adj. Menu containing the following items is displayed.• Adj. Fine Feed (*1)• Printer Info*1:Only displayed in the menu during printing. Not displayed in the regular menu.For instructions on selecting menu items, see "Menu Operations." ➔P.440For details on the displayed menu hierarchy, see "Menu Structure." ➔P.443Paper MenuThe Paper Menu is not displayed during printing.Setting Item Description, InstructionsLoad Paper Select one of Roll 1 (Upper), Roll 2 (Lower), or Cut Sheet.Load the paper in the selected Paper Feed Slot.Eject Paper Remove the paper.(See "Removing the Roll from the Printer.") ➔ P.352(See "Removing Sheets.") ➔ P.373Chg. Paper Type (*1) Change the media type.(See "Changing the Type of Paper.") ➔ P.350Chg. Paper Size Change the size of paper loaded. (See "Specifying the PaperLength.") ➔ P.352 (See "Paper Sizes.") ➔ P.332ManageRemainRoll Choose On to print a barcode at the end of a roll before you re-move it. The printed barcode can be used in managing theamount of roll paper left. Choose Off if you prefer not to print thebarcode.(See "Keeping Track of the Amount of Roll Paper Left.") ➔ P.358Paper Details (The type of pa-per is displayedhere.)(*1)Head Height Adjust the Printhead height. (See "Troubleshooting Paper Abra-sion and Blurry Images.") ➔ P.562Skew Check Lv. If you print on Japanese paper (washi) or other handmade paperthat has an irregular width, choose Loose for a higher skew de-tection threshold, or choose Off to disable skew detection. How-ever, if paper is loaded askew when detection is Off, note that pa-per jams or Platen soiling may occur.Cutting Mode Specify whether or not to cut with the standard round-bladed cut-ter.If you choose Automatic, the roll will be cut automatically usingthe Cutter Unit, depending on the printer driver settings.Select Eject to prevent printed documents from falling immediate-ly after printing such as when you wait for the ink to dry, etc. Man-ual prints lines at the cut position instead of cutting after printing.(See "Specifying the Cutting Method for Rolls.") ➔ P.360Cut Speed Choose the cutting speed. The preset selection represents the op-timal cutting speed for the type of paper. We recommend keepingthe preset cutting speed.If you use adhesive paper, choosing Slow helps prevent adhesivefrom sticking to the cutter and keeps the cutter sharp.Trim EdgeFirst(*2)Selects whether or not to automatically cut the leading edge of theroll paper when roll paper is loaded.iPF850 Menu SettingsUser's GuideControl Panel Printer Menu449