Additionally, two modes are available in both AdjustmentPrint and Change Settings : A:High or B:Standard/Draft. Choose the mode that suits your particular printing application.• A:HighThis setting is applied when Highest or High is selected in Print Quality in the printer driver.• B:Standard/DraftThis setting is applied when Standard or Fast is selected in Print Quality in the printer driver.Important• Perform this adjustment with the Stacker installed on the printer.However, if you are using cut sheets, remove the Stacker from the printer.(See "Installing and Removing the Stacker On the Printer.") ➔ P.376Note• We recommend executing the adjustment if you have changed the paper type or paper size.• Always check the Adj. Priority values before using Adjust Length. (See "Selecting a Feed Amount AdjustmentMethod.") ➔ P.564Paper to PrepareWhen Using Rolls • An unused roll at least 254.0 mm (10.00 in) wide• High-precision rulerWhen Using Sheets • One sheet of unused paper of at least A4/Letter size• High-precision rulerPerform adjustment as follows.1 Load the paper.• Attaching the Roll Holder to Rolls ➔P.342• Loading Rolls in the Printer ➔P.345• Loading Sheets in the Printer ➔P.369Important• Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be comple-ted correctly unless the loaded paper matches the settings.2 On the Tab Selection screen of the Control Panel, press ◀ or ▶ toselect the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.3 Press the OK button.The Set./Adj. Menu is displayed.4 Press ▲ or ▼ to select Adjust Printer, and then press the OK button.5 Press ▲ or ▼ to select Feed Priority, and then press the OK button.6 Press ▲ or ▼ to select Adjust Length, and then press the OK button.iPF850 Adjusting Line LengthUser's GuideAdjustments for Better Print Quality Adjusting the feed amount569
