Setting Item Description, InstructionsPaper Details (The type of pa-per is displayedhere.)(*1)Trim EdgeFirst(*2)(See "Cutting the Leading Edge of Roll Paper Automatical-ly.") ➔ P.366CutDustReduct. If you choose On, a line will be printed at the cut position whenpaper cutting is selected. This option reduces the amount of deb-ris given off after cutting. It also helps prevent adhesive from stick-ing to the cutter and keeps the cutter sharp if you use adhesivepaper. (See "Reducing Dust from Cutting Rolls.") ➔ P.367VacuumStrngth Specify the level of suction that holds paper against the Platen.(See "Adjusting the Vacuum Strength.") ➔ P.570Scan Wait Time Specify the time to wait for the ink to dry between each scan (afterthe printhead finishes moving in one direction), in consideration ofhow quickly the ink dries. Also specify the applicable area for theink drying time. Select Entire area to apply the ink drying time af-ter each scan until the document is fully printed. Select Leadingedge to apply the ink drying time after each scan only in the area110–160 mm from the leading edge. (The applicable length variesdepending on the Print Quality setting.) Note that printing willtake longer if you specify the Scan Wait Time setting. In particu-lar, when Leading edge is selected, colors may be uneven in theboundary between the areas with and without a drying time.Roll DryingTime Specify the time to wait for the ink to dry for each sheet.NearEndRollMrgnSpecify the minimum margin at the leading edge of roll paper toensure better printing quality at the leading edge.Note that if you choose 3mm, it may lower the printing quality atthe leading edge and affect feeding accuracy. The printed surfacemay be scratched, and ink may adhere to the leading edge. It mayalso cause the Platen to become soiled.NearEnd ShtMrgnSpecify a margin at the leading edge of sheets to ensure betterprinting quality at the leading edge.Note that if you choose 3mm, it may lower the printing quality atthe leading edge and affect feeding accuracy. The printed surfacemay be scratched, and ink may adhere to the leading edge.BordlessOver-sizeSelect the amount of oversize extension of the original during bor-derless printing.Normally, we recommend that you set this to Standard.If it is set to Little, although it will reduce soiling on the back sur-face, white patches may remain on the printed surface.Width Detection Specify this option to print inside boundaries or in other caseswhen specifying a particular starting position for printing.Paper width and skew are not detected if you select Off. If paperis loaded askew, paper jams or Platen soiling may occur.Return Defaults Choose OK to restore Paper Details to the default values.Paper Details Print the paper settings as specified in Paper Details.Keep Paper Type Select On when printing on a particular type of paper regularly.(See "Changing the Type of Paper.") ➔ P.350*1:For information on the types of paper the printer supports, refer to Paper Reference Guide.(See "Displaying the Paper Reference Guide.") ➔ P.335The types of paper indicated in the printer driver, related software, and the printer Control Panel as well are updated when youinstall the printer driver from the User Software CD-ROM or if you update the information about the paper by using the MediaConfiguration Tool.(See "Updating paper information.") ➔ P.338 }*2:When using the Stacker, do not set Trim Edge First to on.The cut leading edge of the paper may cause a paper jam.Menu Settings iPF850User's GuideControl Panel Printer Menu450
