display roaming vlan 97Table 21 describes the fields in the display.See Also■ “display roaming vlan” on page 97display roamingvlanShows all VLANs in the mobility domain, the WX switches servicing theVLANs, and their tunnel affinity values configured on each switch for theVLANs.Table 21 Output for display roaming stationField DescriptionUser Name Name of the user. This is the name used for authentication. Thename resides in a RADIUS server database or the local userdatabase on a wireless LAN switch.Station IP Addr IP address of the user WX switch.Old AP MAC MAC address of the access point from which the station isroaming or attempting to roam.Note: This field is applicable only for clients that reassociate withthis WX switch from another WX switch.VLAN Name of the VLAN to which the RADIUS server or WX switchlocal user database assigned the user.State State of the session:■ Setup — Station is attempting to roam to this WX switch.This switch has asked the WX from which the station isroaming for the station’s session information and is waitingfor a reply.■ Up — MSS has established a tunnel between the WX switchesand the station has successfully roamed to this WX over thetunnel.■ Chck — This WX switch is in the process of accepting areassociation request from the roaming peer WX switch for astation currently roaming to the peer switch.■ TChck — This WX switch is in the process of accepting areassociation request from the roaming peer WX switch for astation currently roaming to this switch.■ WInd — This WX switch is waiting for network congestion toclear before sending the roaming indication to the roamingpeer WX switch.■ WResp — This WX switch is waiting for network congestionto clear before sending the roaming response to the roamingpeer WX switch.
