3Com 3CRWX120695A Command Reference Manual

Also see for 3CRWX120695A: User guide User guide Command reference Configuration guide Installation and Basic Configuration Guide

Contents

3Com 3CRWX120695A Command Reference Manual Manual pdf 79 page image

set port poe 79Access — Enabled.History — Introduced in MSS Version 3.0.Usage — WX1200 10/100 Ethernet ports support half-duplex andfull-duplex operation.Examples — The following command disables autonegotiation on ports3 and 5:WX1200# set port negotiation 3,5 disableThe following command enables autonegotiation on port 2:WX1200# set port negotiation 2 enableset port poe Enables or disables Power over Ethernet (PoE) on ports connected to MAPaccess points.CAUTION: When you set the port type for MAP use, you can enable PoEon the port. Use the WX switch’s PoE to power 3Com MAP access pointsonly. If you enable PoE on ports connected to other devices, damage canresult.Syntax — set port poe port-list enable | disable■ port-list — List of physical ports. MSS disables or reenables PoE onall the specified ports.■ enable — Enables PoE on the specified ports.■ disable — Disables PoE on the specified ports.Defaults — PoE is disabled on network and wired authentication ports.The state on MAP access point ports depends on whether you enabled ordisabled PoE when setting the port type. See “set port type ap” onpage 82.Access — Enabled.History — Introduced in MSS Version 3.0.Usage — This command does not apply to any gigabit Ethernet ports orto ports 7 and 8 on the WX1200 switch.