set radio-profile auto-tune channel-holddown 277Syntax — set radio-profile name auto-tune channel-config{enable | disable}■ name — Radio profile name.■ enable — Configures radios to dynamically select their channels whenthe radios are started.■ disable — Configures radios to use their statically assigned channels,or the default channels if unassigned, when the radios are started.Defaults — Dynamic channel assignment is enabled by default.Access — Enabled.History — Introduced in MSS Version 3.0.Usage — If you disable RF Auto-Tuning for channels, MSS does notdynamically set the channels when radios are first enabled and also doesnot tune the channels during operation.If RF Auto-Tuning for channels is enabled, MSS does not allow you tomanually change channels.Examples — The following command disables dynamic channel tuningfor radios in the rp2 radio profile:WX4400# set radio-profile rp2 auto-tune channel-configdisablesuccess: change accepted.See Also■ “set radio-profile auto-tune channel-holddown” on page 277■ “set radio-profile auto-tune channel-interval” on page 278■ “set radio-profile auto-tune power-config” on page 280set radio-profileauto-tunechannel-holddownSets the minimum number of seconds a radio in a radio profile mustremain at its current channel assignment before RF Auto-Tuning canchange the channel. The channel holddown provides additional stabilityto the network by preventing the radio from changing channels toorapidly in response to spurious RF anomalies such as short-durationchannel interference.
