3Com 3CRWX120695A Command Reference Manual

Also see for 3CRWX120695A: User guide User guide Command reference Configuration guide Installation and Basic Configuration Guide

Contents

3Com 3CRWX120695A Command Reference Manual Manual pdf 496 page image

496 CHAPTER 20: S YSTEM L OG COMMANDSDefaults — The following are defaults for the set log commands.■ Events at the error level and higher are logged to the WX console.■ Events at the error level and higher are logged to the WX systembuffer.■ Trace logging is enabled, and debug-level output is stored in the WXtrace buffer.Access — Enabled.History — Introduced in MSS Version 3.0.Usage — Using the command with only enable or disable turns loggingon or off for the target at all levels. For example, entering set log bufferenable with no other keywords turns on logging to the system buffer ofall facilities at all levels. Entering set log buffer disable with no otherkeywords turns off all logging to the buffer.Examples — To log only emergency, alert, and critical system events tothe console, type the following command:WX4400# set log console severity critical enablesuccess: change accepted.See Also■ “clear log” on page 489■ “display log config” on page 492set log tracembytesChanges the size of trace log files.Syntax — set log trace mbytes count■ count — Size of the trace buffer, in megabytes (MB). You can specifyfrom 1 through 50.Defaults — The default trace buffer size is 1 MB.Access — Enabled.History — Introduced in MSS Version 3.0.