3Com 3CRWX120695A Command Reference Manual

Also see for 3CRWX120695A: User guide User guide Command reference Configuration guide Installation and Basic Configuration Guide

Contents

3Com 3CRWX120695A Command Reference Manual Manual pdf 269 page image

set {ap | dap} radio channel 269set {ap | dap} radiochannelSets an MAP radio’s channel.Syntax — set {ap port-list | dap dap-num} radio {1 | 2}channel channel-number■ ap port-list — List of ports connected to the MAP access points onwhich to set the channel.■ dap dap-num — Number of a Distributed MAP on which to set thechannel.■ radio 1 — Radio 1 of the MAP.■ radio 2 — Radio 2 of the MAP. (This option does not apply tosingle-radio models.)■ channel channel-number — Channel number. The valid channelnumbers depend on the country of operation.Defaults — The default channel depends on the radio type:■ The default channel number for 802.11b/g is 6.■ The default channel number for 802.11a is the lowest valid channelnumber for the country of operation.Access — Enabled.History — Introduced in MSS Version 3.0.Usage — You can configure a radio’s transmit power on the samecommand line. Use the tx-power option.This command is not valid if dynamic channel tuning (RF Auto-Tuning) isenabled.Examples — The following command configures the channel on the802.11a radio on the MAP access point connected to port 5:WX1200# set ap 5 radio 1 channel 36success: change accepted.The following command configures the channel and transmit power onthe 802.11b/g radio on the MAP access point connected to port 1:WX1200# set ap 1 radio 1 channel 1 tx-power 10success: change accepted.