set {ap | dap} group 263History — Introduced in MSS Version 3.0.Usage — Changing the LED blink mode does not alter operation of theMAP access point. Only the behavior of the LEDs is affected.Examples — The following command enables LED blink mode on theMAP access points connected to ports 3 and 4:WX1200# set ap 3-4 blink enablesuccess: change accepted.set {ap | dap} group Configures a named group of MAP access points. MSS automatically loadbalances sessions among the access points in a group. To balance thesessions, MSS rejects an association request for an access point’s radio ifthat radio has at least four more active sessions than the radio of thesame type with the least number of active sessions within the group.Syntax — set {ap port-list | dap dap-num} group name■ ap port-list — List of MAP access ports to add to the group.■ dap dap-num — Number of a Distributed MAP to add to the group.■ name — MAP access point group name of up to 16 alphanumericcharacters, with no spaces.Defaults — MAP access points are not grouped by default.Access — Enabled.History — Introduced in MSS Version 3.0.Usage — You can assign any subset or all of the MAP access pointsconnected to an WX switch to a group on that switch. All access points ina group must be connected to the same WX switch.If you use the name none, spelled in any combination of capital orlowercase letters, the specified MAP access point is cleared from all MAPaccess point groups.
