266 CHAPTER 9: MANAGED ACCESS POINT COMMANDSSee Also■ “display {ap | dap} config” on page 234set {ap | dap} radioauto-tunemax-powerSets the maximum power that RF Auto-Tuning can set on a radio.Syntax — set {ap port-list | dap dap-num } radio {1 | 2}auto-tune max-power power-level■ ap port-list — List of ports connected to the MAP access points onwhich to set the channel.■ dap dap-num — Number of a Distributed MAP on which to set thechannel.■ radio 1 — Radio 1 of the MAP.■ radio 2 — Radio 2 of the MAP. (This option does not apply tosingle-radio models.)■ power-level — Maximum power setting RF Auto-Tuning can assignto the radio, expressed as the number of decibels in relation to 1milliwatt (dBm). You can specify a value from 1 up to the maximumvalue allowed for the country of operation.The power-level can be a value from 1 to 20.Defaults — The default maximum power setting that RF Auto-Tuningcan set on a radio is the highest setting allowed for the country ofoperation or highest setting supported on the hardware, whichever islower.Access — Enabled.History — Introduced in MSS Version 3.0.Examples — The following command sets the maximum power thatRF Auto-Tuning can set on radio 1 on the MAP access point on port 6 to12 dBm.WX1200# set ap 6 radio 1 auto-tune max-power 12success: change accepted.See Also■ “set {ap | dap} radio auto-tune max- retransmissions” on page 267■ “set radio-profile auto-tune power-backoff- timer” on page 279
