246 CHAPTER 9: MANAGED ACCESS POINT COMMANDSdisplay auto-tuneattributesDisplays the current values of the RF attributes RF Auto-Tuning uses todecide whether to change channel or power settings.Syntax — display auto-tune attributes[ap map-num [radio {1 | 2 | all}]]Syntax — display auto-tune attributes[dap dap-num [radio {1 | 2 | all}]]■ map-num — MAP port connected to the MAP access point for which todisplay RF attributes.■ dap-num — Number of a Distributed MAP for which to display RFattributes.■ radio 1 — Shows RF attribute information for radio 1.Uptime Amount of time since the MAP last rebooted using this link.Note: This field is displayed only when this link is the MAPaccess point’s primary link.Radio 1 typeRadio 2 type802.11 type and configuration state of the radio.■ The configure succeed state indicates that the MAP hasreceived configuration parameters for the radio and theradio is ready to accept client connections.■ For 802.11b/g radios, 802.11b protect indicates that theradio is in 802.11b protection mode and is thereforeoperating only at 802.11b rates.■ Sweep Mode indicates that a disabled radio isnonetheless participating in rogue detection scans. Eventhough this message appears only for disabled radios, allradios, enabled or disabled, participate in roguedetection.■ Countermeasures Enabled indicates that the radio issending countermeasures packets to combat a rogue.operational channel The channel on which the radio is currently operating.operational power The power level at which the radio is currently operating.base mac Base MAC address of the radio.bssid, ssid SSIDs configured on the radio and their BSSIDs.Table 49 Output for display ap status (continued)Field Description
