display dap global 251The following command displays connection information specifically for aDistributed MAP with serial ID M9DE48B6EAD00:WX1200# display dap connection serial-id M9DE48B6EAD00Total number of entries: 1DAP Serial Id DAP IP Address WX IP Address--- ----------- --------------- ---------------9 M9DE48B6EAD00 10.10.4.88 10.9.9.11Table 52 describes the fields in this display.See Also■ “display {ap | dap} config” on page 234■ “display dap global” on page 251■ “display dap unconfigured” on page 253display dap global Displays configuration information for Distributed MAPs configured onWX switches in the Mobility Domain.Syntax — display dap global [dap-num | serial-id serial-ID]■ dap-num — Number of a Distributed MAP for which to displayconfiguration settings.■ serial-id serial-ID — MAP access point serial ID.Defaults — None.Access — Enabled.History — Introduced in MSS Version 3.0.Table 52 Output of display dap connectionField DescriptionDAP Connection ID you assigned to the Distributed MAP.If the connection is configured on another WX switch, thisfield contains a hyphen ( - ).Serial Id Serial ID of the Distributed MAP.DAP IP Address IP address assigned by DHCP to the Distributed MAP.WX IP Address System IP address of the WX switch on which the MAP hasan active connection. This is the switch that the MAP usedfor booting and configuration and is using for data transfer.
