272 CHAPTER 9: MANAGED ACCESS POINT COMMANDSAccess — Enabled.History — Introduced in MSS Version 3.0.Usage — To enable or disable one or more radios to which a profile isassigned, use the set ap radio radio-profile command. To enable ordisable all radios that use a specific radio profile, use the setradio-profile command.Examples — The following command enables radio 1 on the MAP accesspoints connected to ports 1 through 5:WX1200# set ap 1-5 radio 1 mode enablesuccess: change accepted.The following command enables radio 2 on ports 1 through 3:WX1200# set ap 1-3 radio 2 mode enablesuccess: change accepted.See Also■ “clear {ap | dap} radio” on page 232■ “display {ap | dap} config” on page 234■ “set {ap | dap} radio radio-profile” on page 272■ “set radio-profile mode” on page 287set {ap | dap} radioradio-profileAssigns a radio profile to an MAP radio and enables or disables the radio.Syntax — set {ap port-list | dap dap-num} radio {1 | 2}radio-profile name mode {enable | disable}■ ap port-list — List of ports.■ dap dap-num — Number of a Distributed MAP.■ radio 1 — Radio 1 of the MAP.■ radio 2 — Radio 2 of the MAP. (This option does not apply tosingle-radio models.)■ radio-profile name — Radio profile name of up to 16 alphanumericcharacters, with no spaces.■ mode enable — Enables radios on the specified ports with theparameter settings in the specified radio profile.
