SERVO SELECTION AND DATA SHEETS5.6.12 Regenerative cont.3782) JUSP−RG08C typeJUSP−RG08C type is an exterior type regenerative unit. When regenerative ability of thebuilt−in resistor is insufficient, install this regenerative unit to enhance the regenerativeability. When regenerative resistor is installed externally, disconnect the jumper cablebetween terminals Y4 and Y5. Connect exterior type regenerative unit between termi-nals P/Y3 and Y4.• Dimensional DrawingsM4 External Terminal ScrewsApprox. Mass: 1 kg (2.20 lb)Hole 6 dia.(Φ0.24)(1.97)(0.98)(0.73) (5.12)(6.30)(5.12)(5.87)(0.20)(0.59)(0.24)(0.24)(0.98)(0.59)Nameplate• Regenerative Unit SpecificationsType JUSP−RG08C RemarksApplicable Servopack Only for 200 V, 30 to 200 WspecificationsRegenerative WorkingVoltage380VdcRegenerative ProcessingCurrent8Adc Regenerative Resistance:50 Ω, 60 WError Detection Function Regenerative resistancedisconnection, regenerativetransistor fault, overvoltageMinimum Exterior Resistance 50 ΩAlarm Output Normally closed contact(open when protectivefunction operates)200 V operation OKDimensions in mm(inches)55W¢160H¢130D(2.17W ¢ 6.30H¢ 5.31D)5
