3-16 Macintosh Setupbb ____________________________________Note: If your printer has two cassette trays, selectUpper Optional Tray: Installed. If it has threecassettes, select Upper Optional Tray: Installedand Lower Optional Tray: Installed.b. Select True for Spooler Enabled to activate the SaveSpooled Job menu in your application Print dialog box ifyour system has an optional internal hard disk.Note: This does not enable the Spooler on your printer.The Spooler must be enabled using either the frontpanel Interface menus or XANTÉ CommandCenter. See “Spooler” in chapter 6 and “Spooler”later in this chapter for details.c. Select the amount of RAM installed on your printer.8. Click OK twice. The Chooser window reappears. Then, closethis window.Note: When you add a printer from the network, go through eitherthe Auto Setup or manual setup procedure to ensure that theprinter is recognized by the network.Configuring the PrinterIf necessary, configure the printer’s communication interface usingthe front panel. See Chapter 6, “Configuration,” for details.1. Select the SETUP:I/F menu.2. Select the menu for the printer interface connected to yourcomputer (LTALK or ETALK).3. Select the ENABLE menu. Then, choose YES.4. Press the Reset key until READY/IDLE appears.
