_______________________________________ Ethernet Setup 5-195. If a password is required to access the file server, change theprint server password to agree with the password set up on thefile server.Note: If no password is required to access the Novell server,this step is not required.a. Choose Networking: Novell Print Server: Set PrintServer Password.b. Type in the password exactly as it was entered on the fileserver; then click Ok to return to the main menu. Thepassword must follow Novell NetWare namingconventions, and lower-case letters will be converted toupper-case.Note: The printer enters a waiting state while it savesthe file server name. Do not proceed until theprinter displays READY/IDLE.6. Repeat steps 2 through 5 to add up to four file servers.7. Print a start-up page by taking the printer off line, pressing thefront panel Test button, and then putting the printer back on line.Check the page to be sure the new print server name is enabled.8. Go to “Configure the Novell Print Server Interface” later in thischapter to continue configuration. To complete configurationusing the printer front panel menus, rather than XANTÉCommand Center, choose File: Quit. Command Center closes.Configure the Novell Print Server InterfaceUse XANTÉ Command Center and printer front panel menus to enableyour printer’s Novell Print Server interface and to configure timeout andframe type options for your network environment:• To enable the Ethernet Interface, which directs the printer tologin to listed file servers and begin printing jobs from assignedprint queues, use either Command Center or printer front panelmenus.
