Xante ScreenWriter 3 Manual 

Also see for ScreenWriter 3: Supplementary guide

Contents

Xante ScreenWriter 3 Manual  Manual pdf 142 page image

5-4 Ethernet Setupbb ______________________________________• Select the Phase 2 driver through the Network Control Panel underApple menu: Control Panels on a Macintosh with an older operatingsystem (System 6.X and earlier).• Select Ethernet from the drop down menu in the AppleTalk ControlPanel under Apple Menu: Control Panels on a Macintosh with anoperating system that supports Open Transport (System 7.5 andlater and some versions between 6.X and 7.5).Change the EtherTalk Zone NameOn an EtherTalk network with more than one zone, the networkrouter assigns your printer a default zone. Check with your SystemAdministrator to determine the correct zone for your printer; then, ifnecessary, change the printer’s zone name using XANTÉ CommandCenter.Using XANTÉ Command Center1. Open XANTÉ Command Center by double-clicking its icon.2. Choose Networking: AppleTalk: EtherTalk Zone Name.Fig. 5.1 EtherTalk Zone Name Window3. Enter the new name for the EtherTalk zone.Note: EtherTalk zone names are limited to 32 characters, arenot case sensitive, and cannot include the = (equal), ≅(approximately equal), * (asterisk), : (colon), or @(at) characters.4. Click OK. Command Center’s main menu reappears.