5-6 Ethernet Setupbb ______________________________________Selecting the Novell NamesCertain characters are invalid for use in Novell names (fig. 5.2). TheNovell utility automatically replaces any of these characters in theprinter’s default name with an underscore (_) character and changesall characters in the name to uppercase.space ( ) less-than sign (<)double quote (") equals sign (=)asterisk (*) greater-than sign (>)plus sign (+) question mark (?)comma (,) left bracket ([)forward slash (/) backward slash (\)colon (:) right bracket (])semi-colon (;) vertical bar (|)Fig. 5.2 Invalid Characters for Novell NetWare NamesYour printer’s default Novell print server name appears on thestart-up page after the Ethernet board is installed. The default printserver name is formed by adding a _PS extension to your printer’sPostScript name. The printer PostScript name ScreenWriter 3becomes the default print server name SCREENWRITER_3_PS.The Novell System Administrator may assign a print server nameother than the default and may assign a password to control access tothe server.Note: The print server name on the printer must match thecorresponding print server name on the Novell file server.For example use xante_ps for both of these names. It also isrecommended that you name the Novell file server queue asimilar name such as xante_q.Both the print server name and the password must follow NovellNetWare naming conventions (fig. 5.2). On the printer, the passwordis case sensitive and write-only.Note: Do not set passwords for access to the server unless necessary.If a password has been set for a printer, it must be reset to a nullpassword before you can make changes to the printer’s Novellsetup in XANTÉ Command center. See “Configure the PrintServer Emulation” later in this chapter to set the password.
