|
SARA-R4/N4 series - AT Commands ManualUBX-17003787 - R09 B Appendix: AT Commands ListPage 293 of 307AT command Description AT interfaceconfigurationsharingFactory-programmed value / RemarksV DCE responseformatNo 1 (Verbose response text)X Result code selectionand call progressmonitoring controlNo 4 (CONNECT result code is given upon entering onlinedata state; dial tone and busy detection are both enabled)B.2 Parameters stored in non volatile memoryThe following table lists the AT commands which setting can be stored in the non volatile memory with theirparameters and the factory-programmed values.AT command Description Factory-programmed value / Comment+CCLK Clock 04/01/01,00:00:00+00+CEMODE UE modes of operation for EPS • SARA-R4 / SARA-N4 - 2 (CS/PS mode 2 of operation; "data centric")+CGDCONT PDP context definition • SARA-R4 / SARA-N4 - all contexts are undefined+CPMS Preferred message storage • SARA-R4 / SARA-N4 - , and are set to"ME"+CPSMS Power Save Mode • SARA-R4 / SARA-N4 - 0 (PSM disabled)+CSAS Save settings 0 (profile 0 where to store the active message settings)+CSGT Set greeting text Greeting text is empty+CTZU Automatic time zone update • SARA-R4 / SARA-N4 - 0 (automatic time zone via NITZ disabled)+UBIP Bearer Independent Protocolstatus indication0 (BIP status indication disabled)+UDCONF=75 PDP IP configuration whenroaming• SARA-R4 / SARA-N4 - no context is undefined+UDCONF=76 Configure data when roaming • SARA-R4 / SARA-N4 - no context is undefined+UFOTACONF LWM2M configuration 1 (module registration to uFOTA server enabled, 604800 (7 days astimer for the periodic connection to the uFOTA server)+UGGGA Get GPS fix data 0 (NMEA $GGA messages disabled)+UGGLL Get geographic position 0 (NMEA $GLL messages disabled)+UGGSA Get satellite information 0 (NMEA $GSA messages disabled)+UGGSV Get number of GNSS satellitesin view0 (NMEA $GSV messages disabled)+UGPIOC GPIO functionality setting • SARA-R4 / SARA-N4 - 255 (), 255 (), 255 (),255 (), 255 (), 255 ()+UGPRF GNSS profile configuration 0 (No data flow on multiplexer, file and IP address), 0 (IP port notdefined), "" (Server address string not defined)+UGRMC Get recommended minimumGNSS data0 (NMEA $RMC messages disabled)+UGSRV Aiding server configuration "cell-live1.services.u-blox.com" (primary MGA server), "cell-live2.services.u-blox.com" (secondary MGA server), 14 (Number of daysfor validation of Offline data), 4 (Number of weeks for validation ofOffline data), 1 (Resolution of offline data for MGA), 65 (Desired GNSSfor the (offline) aiding: GPS and GLONASS), 0 (AssistNow Online dataare downloaded at GNSS receiver power up), 15 (all the desired datatypes for the (online) aiding are set)+UGVTG Get course over ground andground speed0 (NMEA $VTG messages disabled)+UGZDA Get GPS time and date 0 (NMEA $ZDA messages disabled)+ULGASP Last gasp configuration • SARA-R4 / SARA-N4o : 0 (disabled)o : ""o : 0 (text)o : 1o : 17 (UDP)o : "" (empty)o : 1 (use IP (TCP or UDP) connection)o : 1 (URC enabled)
|
