SARA-R4/N4 series - AT Commands ManualUBX-17003787 - R09 10 V24 control and V25terPage 103 of 307Type Syntax Response ExampleOK OK10.11.3 Defined valuesParameter Type Description Number Range 1 to 255. The answer to the read command is in "xxx" format. The default andthe factory-programmed value is 43 (ASCII '+').10.11.4 NotesSARA-R4 / SARA-N4• The following table shows how the ATS2 command works for different data call scenarios.Data call command L2 protocol Description ATS2 behaviorATD*99***1# PPP PSD call: dial up Escape sequencedetection is only done for ~+++. ATS2 is not effective.There is not a timingconstraint (see the S12 ATcommand) for ~+++ (+++ is incapsulated in a PPPframe)ATD1234 CSD call The command is effectiveif issued in both commandand online command modeAT+USODL=0 PSD call: Direct Link mode The command is effectiveAT+USOWR=0,32 PSD call:AT socket (not transparent) Break detection is notsupportedTable 8: ATS2 handling for different data call scenariosSARA-R4 / SARA-N4• The command has no effect.10.12 Command line termination character S3S3SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412MModulesSARA-N4Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributespartial No Profile No - +CME Error10.12.1 DescriptionSets a value representing the decimal IRA5 value of the character recognized by the DCE from the DTE,to terminate the incoming command line. It is also generated by the DCE as part of the header, trailer andterminator for result codes and information text, along with the S4 setting.10.12.2 SyntaxType Syntax Response ExampleSet ATS3= OK ATS3=13OKRead ATS3? OK013OK10.12.3 Defined valuesParameter Type Description Number Range 0 to 127. The answer to the read command is in "xxx" format. The default andthe factory-programmed value is 13 (ASCII carriage return (CR, IRA5 0/13)).
