Menu
Siemens 6SN1123-1AA00-0DA2 Configuration Manual
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                     |
905.019.1 Installation and connecting–up regulations9-337© Siemens AG 2012 All Rights ReservedSIMODRIVE 611 Configuration Manual (PJU) – 02/2012 EditionGFunctionalcablesPE rail electrically connected over a large surface area to the cabinet mounting panel3)Cabinet mounting panel1) I/R moduleorUI module2)MSD module FD moduleP600M6002)M M1)1)1)1)Supplysystem1) Shield connection through the largest possible surface area to the cabinet mounting panel.2) Shield connection at the module–specific connecting plate.Encoder cables1)1)FusesInput terminals Main switchesPE PEL2 L3L1 PEV1U1 W13) PE cables can be, alternatively, connected using a PE rail also observing EN50178(protective connections).V2U2 W2 PEV2U2 W2433 3Reactor1)1)3 3LOADLINEPEFilterPE2)G4) Permissible commutating reactors for I/R module, sinusoidal operation – refer to Sections 3.4.2 and 3.1Permissible commutating reactor for 28 kW UI module, refer to Section 3.4.2When routing cables into the cabinet, a clearance of > 100 mm must be maintained around the HFD reactor ormeasures must be taken to discharge the heat/appropriately guide the air.4)Note:The filter may only be mounted with the line supply connection at the bottom (downwards).Cables longer than 1 m must be shielded. If unshielded connections are used, an adequateseparation > 20 cm must be observed for cables subject to coupling!Fig. 9-1 Connecting diagram for line filters for 5 kW and 10 kW U/I modules and for 16 kW to 120 kW I/R modules.The connecting diagram also applies to –28 kW UI, – however as a result of the unregulated infeed, 6–pulsesquarewave current is drawn.Note1. The EMC measures described above ensure CE compliance with the EMCDirective.2. Alternative measures can be applied, e.g. routing behind mounting plates,suitable clearances, under the assumption that they have similar results.3. This excludes measures that relate to the design, installation, and routing ofmotor power cables and signal cables.9 Cabinet Design and EMC02.12 |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved