Menu
Siemens 6SN1123-1AA00-0DA2 Configuration Manual
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                     |
905.019.1 Installation and connecting–up regulations9-336 © Siemens AG 2012 All Rights ReservedSIMODRIVE 611 Configuration Manual (PJU) – 02/2012 EditionThe line filter must be located in the same cabinet field close to the NE mod-ules; the cable (shielded above 1 m) connecting the line filter to the NE moduleshould be kept as short as possible. The incoming and outgoing cables to/fromthe line filter must be routed separately from one another.Recommended configuration, refer to Fig. 9-1.NoteIf the system is subject to a high–voltage test using AC voltage, a line filtermust be disconnected in order to obtain a correct measurement result.A permanent strain relief for the cables must be present. These cables must notpass strain forces to the cable shielding!Shield connecting plates with a clamp connection are provided on the NE andPM modules to connect the shields of shielded powered cables; mounting loca-tions are also provided for brake terminals (Order No., refer to Table 9-1. Alsorefer to the dimension drawing ”EMC measures”, Chapter 12).Table 9-1 Order Nos. for the shield connecting platesModule width [mm] Shield connecting plate for modules withinternal cooling6SN1162–0EA00external cooling6SN1162–0EB0050 –0AA0 –0AA0100 –0BA0 –0BA0150 –0CA0 –0CA0200 –0JA0 –0JA0300 –0DA0 –0DA0300 for fan/hose –0KA0 ––––––––––If the motor is equipped with a brake, then the shield of the brake feeder cablemust be connected at both ends to the shield of the power cable.If there is no possibility of connecting a shield on the motor side, a gland mustbe incorporated in the terminal box with the possibility of establishing a shield–motor connection through the largest possible surface area.! WarningCable shields and cores/conductors of power cables which are not used, e.g.brake conductors, must be connected to PE potential in order to dischargecharges arising from capacitive coupling.Non–observance can cause lethal shock voltages.Mounting in theelectrical cabinetConnectioncable shield9 Cabinet Design and EMC 05.08 |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved