Samsung iDCS 500 Programming Manual

Also see for iDCS 500: User guide User guide User guide Administration guide User instruction

Contents

iDCS 500 PROGRAMMINGTECHNICAL MANUAL PART 2 JUNE 2002MMC: 4252 DLSEND OVERLAP Digits will be sent as they are dialed by theuser. This is the usual setting for the U.S.operation.ENBLOCK Digits will be collected and sent in a singleblock similar to a Cell phone. This setting isgenerally not used in the U.S.3 SWH The ISDN protocol you wish to run on this BRIcircuit (e.g., NI_2, 5ESS10, DMS100).4 TIMER The ISDN T200 and T300 series timer values(note: do not change these since defaults arecorrect for U.S. operation).OPTIONS FOR BRI PORTS PROGRAMMED AS STATIONS IN MMC 4270 ANY CHANNEL When this option is set to YES, the system willplace calls on any free channel of that BRI ifthe channel chosen by the user is busy (i.e.,Preferred channel selection). If set to NO, theuser will receive a busy signal if they attempt toaccess a busy channel even if the otherchannel on that BRI is free (i.e., Exclusivechannel selection).1 POWER FEED This is set to NO for all U.S. applications.2 SWH The ISDN protocol you wish to run (e.g., NI_2,5ESS10, DMS100).3 TIMER The ISDN T200 and T300 series timer values(note:do not change these since defaults arecorrect for U.S. operation).4 CLI TABLE This refers to the table in MMC 321 that will beused for Calling party number (the CLI that issent).